Do you know that power analysis is one of the most common application done using an oscilloscope? Today’s power supply designers are faced with increasing pressure to achieve power conversion efficiencies of 90% and higher.

Moreover, the advancement of power conversion components and more stringent design requirements have far outpaced the ability to accurately measure and characterize these designs.

In order to make accurate measurements, the power measurement system must be setup correctly to precisely capture waveforms for analysis and troubleshooting. Do know what are the selection criterium for probes and oscilloscopes for power measurements? How do you prepare your test equipment for the measurements?

During this session, you will learn how to:

  • Select suitable probes for power measurement
  • Perform probe deskewing, AutoZero and degaussing for accurate measurement.
  • Perform power measurements effectively using combination of Tektronix oscilloscope and automated power analysis software

Register to watch

Presenter

Ronald Dung

Carl Wong

Regional Application Engineer

As Regional Application Engineer, Carl is responsible for a wide range of oscilloscope applications from power conversions to serial bus communications and component test.

Carl was previously a Component Materials Engineer in Keysight Technologies where he worked in the supply chain organization dealing with Keysight's strategic suppliers to ensure the quality and assurance of supply of wide range of RF components.

He graduated from University of Nottingham with First Class Honors in Master’s Degree in Electrical & Electronic Engineering.